HOW TO WIRE A
LAMBRETTA 12 VOLT CONVERSION
The best set up for a Lambretta is a modern 12v
CDI system, but that generally requires a new GP
flywheel and crankshaft. However, you can easily
change a standard 6v Lambretta to 12v wiring and
get better lighting. If you keep the regular
coils, though, you won't get enough power.
Change the coils to ones specifically wired for
12v and you'll be much happier with the result.
To make the change, you will need our 12v stator
coils and regulator, and can then add 12 volt
bulbs. We highly recommend a halogen bulb. You
should also change to a new Vespa coil. These
items are found in the Lambretta Electrical and
Lighting sections.
If you have an old junction box, remove it. Use
the following diagram to wire the stator with no
battery when you add the coils we sell.
The black wire goes to ground, and the
blue/green is unchanged.
The red wire will go to the regulator, which
you can mount above the rear mudguard. With
the plastic part facing down, the left side
has two prongs. Either one is fine to plug
into. (If you have a CDI system, another red
wire will come to it, otherwise nothing.) On
the right side is only one prong and it goes
to ground.
By the way, your horn is 6v, but will work
at 12v.
If you have any questions, our professional & friendly customer
service staff will stand by to assist you.
STAR VESPA
24 hours Order: +84 9081
28158
Email: sales@starvespa.com
& starvespa@gmail.com &
support@starvespa.com
+84 9081 28158
